Integrating Robus into your electronic design
A Robus-friendly electronic board must contain At least two connectors. They allow to link boards together into a Robus network and link them as a daisy-chain or star mounting. Through PTP pins, the nodes know if there is another node connected to the connector. This is used when the user wants to make a topology detection of the system.
Robus reference designs
- One-wire
- RS485
Robus' One-wire official connector is DF11-4DP-2DS.
Robus' RS485 official connector is DF11-8DP-2DS.
See the default pinout configuration in the luos_hal_config.h file, situated in the folder associated to the chosen MCU family.